Horizon Global CQT76338 Instrucciones De Instalación página 7

4. Install Hitch - Raise hitch into position aligning holes with studs in end panel. See Figure 1. Loosely reinstall the (8) existing M12 bolts into end panel. Tighten all
M12-1.50 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Existing M12 Bolts
(8) Places
5. Trim fascia –Locate the center of the fascia. Using a tape measure, marker, and utility knife, cut a notch in the bottom of fascia approximately 4'' wide by 4" tall.
See Figure 3. Note: Be sure area is clear of all electrical wiring before trimming.
Area to trim
©2020 Horizon Global™ Corp - Printed in Mexico
End panel
Proper torque is needed to keep the hitch secure to the vehicle
when towing.
Figure 1
C
L
4"
Figure 3
4"
Sheet 7 of 24 76338NP 06-17-20 Rev. A