Step1: Preparing Cabinet Opening; Step2: Preparing Electrical Wiring - Signature Kitchen Suite UPDF9904ST Manual Del Propietário

10 INSTALLATION
Step1: Preparing Cabinet
Opening
1
This dishwasher is designed to fit a standard
dishwasher opening.
2
Select a location as close to the sink as possible
for easy connections to water and drain lines.
3
To ensure proper drainage, the dishwasher
should not be installed more than 12 ft. (3.65 m)
from the sink.
4
If the dishwasher is to be installed in a corner, a
minimum of 2 in. (50 mm) is required between
the dishwasher and the adjacent wall.
5
To allow for proper clearance of plumbing and
electrical, use the template included with the
literature to determine the clearance on the side
of the cabinet where the cabinet meets the back
wall. Using a 2 / " diameter hole saw, drill a hole
1
2
in the target area as shown on the template. DO
NOT USE AN EXISTING HOLE UNLESS IT IS
IN THE TARGET AREA.
CAUTION
Failure to properly locate the hole for the water
and drain lines may prevent the dishwasher from
installing flush with the cabinets and could result
in kinked or damaged lines. Installation damage
is not covered by the warranty, and leaks caused
by improper installation may result in property
damage.
An opening may be needed on both sides to route
plumbing and electrical connections.
24" (610 mm) min.
33 / " (851 mm) min.
1
2
24" (610 mm) min.
Don't use existing holes unless they are in the
target area. Otherwise, the water supply and
drain hose may be damaged by being crushed or
kinked.
For flush installations ONLY, you may remove the
cabinet brace inside the cabinet.
Step2: Preparing Electrical
Wiring
• For personal safety, remove house fuse or open
• Do not use an extension cord or adapter plug
1
USE TARGET
2
AREA ONLY
WARNING
Cabinet brace
WARNING
circuit breaker before installation.
with this dishwasher. Electrical and grounding
connections must comply with the National
Electrical Code/provincial and municipal code
and/or other local codes.
This appliance must be operated with correct
voltage as shown in this manual and on the
rating plate, and connected to a dedicated
properly grounded branch circuit, protected by a
time-delay fuse. Wiring must be 3 wires including
the ground.
If an outlet and a three-prong power cord is
used, it should be in an accessible location
adjacent to and not behind the dishwasher and
within 4 ft (1.2 m) of the dishwasher's side.