Step10: Connecting Water Supply - Signature Kitchen Suite UPDF9904ST Manual Del Propietário

Connecting to Disposal or Waste Tee
with Air Gap
1
Remove the knockout plug with a hammer and
screwdriver.
2
Connect end of the drain hose to the air gap with
hose clamp provided. It is to avoid water being
siphoned from the tub.
Air gap
Rubber hose
connector
3
Attach the rubber connector to disposal or waste
tee with the hose clamp provided. Move into
position and tighten the hose clamp.
Connecting without Air Gap
The height of the drain hose end must be at least 12"
(30.5 cm) and within 40" (101.6 cm) from the base of
the appliance to avoid water being siphoned from the
tub.
40"
(101.6 cm)
max.
12"
(30.5 cm)
min.
Drain pipe
Drain hose
Step10: Connecting Water
Supply
1
Before connecting, turn off the water supply.
2
Slide the flexible stainless-steel water line or
copper tube into the elbow.
3
Tighten the compression nut and make sure that
the line is not kinked or pinched.
NOTE
During the final installation check of the
dishwasher, an IE error code may appear on the
display. Make sure the water line is not kinked
and the water supply for the dishwasher has been
turned on before calling for service.
Elbow
15
INSTALLATION
Water
supply line