ISO DIN radio provision with pocket
1. Attach the radio brackets to the radio
housing using the (4) #8 x 1/2" Phillips
screws supplied. (Figure A)
2. Slide the radio into the radio housing/
bracket assembly, and then secure the
radio to the assembly using the screws
supplied with the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
4
KIT ASSEMBLY
(Figure A)
(Figure B)
4. Remove (4) Philips screws securing
the glove box liner. Remove the liner
to access the sub dash area where
the aftermarket radio will be located.
Remove the plastic cover over the
factory wiring and tuck the wiring low
and to the back. (Figure C)
5. Reassemble the dash in reverse order
of disassembly.
(Figure C)
|
1.800.221.0932
MetraOnline.com