Kit Assembly; Iso Din Head Unit Provision With Pocket - Metra 99-8232B Instrucciones De Instalación

ISO DIN head unit provisions with pocket
1. Remove the factory panel clips and
attach to the Metra radio trim panel in
the same order. This kit comes with six
panel clips that will only work with the
upper six locations around the vents.
The two lower clips must be factory.
2. Mount the climate control to the factory
brackets with the factory hardware.
(Figure A)
3. Mount the pocket to the climate control/
bracket assembly with the (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
4. Slide the head unit into the bracket
assembly and secure with screws
supplied with the unit. (Figure A)
5. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
6. Mount the radio/pocket/climate control
assembly into the dash.
7. Reassemble dash in reverse order of
disassembly using the 99-8232B
radio trim panel.
Kit Assembly 99-8232B
6
(Figure A)