Federal Signal LP3 Serie Instrucciones Para La Instalacion Y Mantenimiento página 3

SAFETY MESSAGE TO INSTALLERS, USERS AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is to be installed by a
trained electrician who is thoroughly familiar with the National Electrical Code/Canadian Electrical
Code and will follow the NEC/CEC Guidelines as well as local codes.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the facilities engineer and the safety engineer. In addition,
listed below are some other important safety instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this equipment.
• Disconnect light from the power supply before any installation or maintenance is performed.
• After installation, test the light system to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction sheet to all operating personnel.
• Establish a procedure to routinely check the light installation for integrity and proper operation.
• The product nameplate, which may contain cautionary or other information of importance to
maintenance personnel, should not be obscured in any way.
Failure to follow all safety precautions and instructions may result in property damage, serious
injury, or death.
I. INSTALLATION
A. Unpacking
After unpacking the light, examine it for damage that may have occurred in transit. If the
equipment has been damaged, do not attempt to install or operate it. File a claim immediately
with the carrier stating the extent of the damage. Carefully check all envelopes, shipping labels
and tags before removing or destroying them.
B. Mounting
The Model LP3M lights are designed for mounting on a flat surface or in a 1/2" NPT hub.
1. Hub Mounting
a. Locate gasket on mounting surface and align light with hub opening.
b. Thread light into hub by turning clockwise.
c. Refer to section D for information on making electrical connections.
2. Panel Mounting
a. Drill or punch 7/8" (22.2 mm) diameter hole in mounting surface.
b. Locate gasket on mounting surface and set light on top of gasket. Tighten supplied locknut
to secure the light.
c. Refer to section D for information on making electrical connections.
INSTALLATION AND SERVICE INSTRUCTIONS FOR
STREAMLINE LP3M STROBE LIGHTS
-1-