Exterior Or In-Line Blower Only - Best D49M30SB Manual Del Usuario

Exterior or In-Line Blower only

CAUTION
All electrical wiring should be done by a qualified
person(s) in accordance with all applicable codes
and standards.
• If using a remote blower (purchase separately), the
system draws 6.0 Amps (max.) and requires a 120 VAC,
60 Hz circuit.
• The unit has a 30 in. long power cord with a 3-pronged plug.
Plan to provide a grounded outlet in a location which will allow
the unit's power cord to reach.
• Install electrical box according to local codes.
18b
Mount a standard wiring box, with 3-pronged receptacle, within
reach of downdraft's power cord. Run appropriate power cable and
connect it to receptacle.
19b
I
Remove wiring box cover and route blower wire into wiring box.
From Exterior or From Exterior or
In-Line Blower In-Line Blower
Electrical Wiring Installation
20b
Connect blower wires to wires in wiring box. Replace wiring box cover.
Note: Blue, gray and orange wires are capped off but not connected.
21b
Plug electrical panel cover into lower receptacle as shown.
22b
Plug downdraft's power cord into outlet.
Note: Make sure that power cord is routed away from the heat
generated by the cooktop.
18
Green (ground) Green (ground)
White White (neutral) White White (neutral)
Blue Blue
Gray Gray
Orange Orange
Black Black (high 4) Black Black (high 4)