User Mode; Ignition Of The Stove; Stove In Operation; Change Of The Set-Point Room Temperature - BOREAL AIRE Serie Instrucciones De Instalación, Uso Y Mantenimiento

EN
SMOKE
EXTRACTION
SPEED
AUGER SPEED
9.4

USER MODE

Below is a description of the display normal operation according to the available
functions.
Before the ignition of the stove, the display shows the following screen. It is showed up
the "off" state, the room temperature, the established working power and the current
hour.
9.4.1

IGNITION OF THE STOVE

In order to ignite the stove, press button no.4 during a few seconds. After a few
seconds while the resistance is heating up and it shows the text "wait", immediately
after the stove begins the start-up process. The display will show the ignition state as
follows.
The maximum length of the ignition phase is 25 minutes. After this time, if there is no
visible flame, the stove will automatically go into the alarm state and the display will
show the message "Ignition Failure."
9.4.2

STOVE IN OPERATION

The hot air fan will start when the smoke temperature reaches a minimum. Auxiliary fans
(in case of models of stoves Lola, Sara, Clara Extra, Cleo Extra and Olivia Extra) will
start only if enabled.
In this moment, the display will show the message "Work." After this, our stove will be
working normally.
The display shows the ambient temperature in the room.
9.4.3

CHANGE OF THE SET-POINT ROOM TEMPERATURE

In order to modify the setting room temperature, please press button 1 and 2 to
increase or decrease it respectively.
9.4.4

ROOM TEMPERATURE REACHES TEMPERATURE FIXED BY THE USER

When the ambient temperature (of the room) reaches the value set by the user or the
smoke temperature reaches a too high value, the stove will automatically operate at one
lower power; it means that modulates in power.
Remember that if it is activated "stand-by mode", when the ambient temperature reaches
the value set by the user plus a differential (2ºC) the stove will be automatically turned
off and will be on hold until the ambient temperature falls to the set temperature minus a
differential (2ºC). After that, the stove restarts automatically.
32
TIME 1 REMAINING TIME INTERMEDIATE CLEANING
10"
82'
RAL
STATE
STATE ALARM DELAY
SMOKE
TEMPERATURE
FAN 2 AND 3 SPEED (NOT AVAILABLE)
117º C
1100
V1-2 V3-3
STATE 4
STATE
POWER
1,5"
P-5
LOAD
DIALOGUE
20
4
OPERATIONAL STATE
OPERATIONAL STATE
STATE
AL8
FAILURE
ASPIRATION
ALARM IN PROCESS
14:24
21 ºC P-2
OFF
14:35
21 ºC P-2
IGNITION
15:18
21 ºC P-3
WORKING
24 ºC
SET TEMP
ROOM
16:40
27 ºC P-2
WORKING
MODULATION