Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
NOTE:
Hitch does not fit with
full size spare tire
Conical washer
Fasteners
teeth side
typical
against hitch
both sides
Centerline of fascia
Edge of
fascia
Figure 2
1. Lower spare tire – open the trunk, using tools under storage compartment, lower the spare tire.
2. Trim fascia – using hack saw, trim the bottom center of fascia shown in Figure 2.
3. Install hitch – using tap, remove paint/debris from weldnuts, both sides. Raise the hitch into position. Using 22mm socket, loosely
install M14 bolt ① and conical washer ② into weldnut, see Figure 1.
4. Tighten all M14 CL10.9 fasteners with torque wrench to 148 Lb.-Ft. (201 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5. Raise spare tire – raise the spare tire back into position. Make sure the spare tire won't interfere with hitch.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe
safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76453, 84453, CQT76453
Existing
Weldnuts
4.00"
3.50"
①
②
Frame rails
Figure 1
Rear
Sheet 3 of 12
76453NP
Fastener kit: 76453F
Qty. (6)
Bolt M14
1.50 x 45, CL10.9
Qty. (6)
Conical washer
5/8''
Spare tire
②
①
06-04-21
Rev. B
Publicidad
