DeWalt DE7025 Traducido De Las Instrucciones Originales página 19

DE7025 HARDWARE SELECTION CHART
Left Side
DW703 1
DW705 1
DW706 1
DW708 1
DW712 1
DW713 1
DW715 1
DW716 1
DW717 2
DW718 3
DW700 4
DW701 Type 1 4
DW701 Type 2 1
DW707 Type 1 4
DW707 Type 2 1
DW711 Type 1 4
DW711 Type 2 1
DW771 1
DW777 1
1 = Long screw, head on
bottom
2 = Short screw, head on
bottom
3 = Long screw, head on
top
4 = Plastic pad and small
screw, head on bottom
4. Once the carriage bolt (hardware bag) is
installed per DE7025 Hardware Selection
Chart, assemble a flat washer, lock washer and
nut onto the bolt. Tighten the bolts finger tight.
5. Repeat procedure on the other end of the
bracket.
6. Move the spacer to the other side of the saw
to hold the other end of the saw up in order to
Right Side
access the saw base.
1
1
7. Feed carriage bolts through the other bracket
1
and the base of the saw as before. Ensure both
2 brackets are parallel to each other.
2
8. To place the saw onto the stand, grasp and
1
lift saw by mounting bracket assembly by the
release levers. These levers do not lock the saw
1
laterally in place but merely serve as a means of
1
mounting the saw to the beam.
1
9. Approach the beam with saw/bracket assembly
2
tilting toward your body slightly. Engage the
4
concave front lip of the mounting bracket with
4
rounded edge of beam. One of the brackets
1
must engage the locator clip (d) to prohibit
4
lateral movement of the saw during use.
1
10. When the front edge of the beam and locking
4
locator clip are engaged, a slight downward
pivot will allow secure engagement of the
1
release levers to the back of the beam. Rock
1
the saw gently on the brackets to verify locking
1
in position.
11. Adjust the saw position as necessary to have
the blade perpendicular to the beam when in
the 0 degree mitre position.
12. Tighten the four nuts holding the saw to the
brackets securely.
DE7025 Universal Mitre Saw
Mounting Method (fi g. 1, 3–5)
WARNING: For your own safety,
read and understand the mitre saw
instruction manual before using. Failure
to heed these warnings may result in
personal injury and serious damage to
the mitre saw and the accessory.
WARNING: To reduce the risk of
injury, turn unit off, disconnect
machine from power source before
assembling the mitre saw to the
mitre saw stand. An accidental start-
up can cause injury.
WARNING: Stability Hazard. You must
use the plywood mounting method
described in the following instructions
when mounting a mitre saw not
manufactured by D WALT to this mitre
E
saw stand.
WARNING: To reduce the risk of
personal injury, be sure the mitre saw is
fully anchored on the stand.
EN G LI SH
17