Debris Between Blades; Use Environment - Össur PRO-FLEX LP ALIGN Instrucciones Para El Uso

DEBRIS BETWEEN BLADES

• Noise may occur if sand or debris are present between blades.
• The prosthetist should remove the Spectra sock and foot cover from
the device, and use compressed air to remove sand or debris.
N.B. The device should always be used with a foot cover and Spectra
sock to minimize dust and dirt from entering between carbon blades.

USE ENVIRONMENT

Environmental operating temperature: -15 °C (+5 °F) to 50 °C (122 °F).
Operating humidity: 10-95% relative humidity.
Shipping and storage temperature: -20 °C (-4 °F) to 70 °C (158 °F).
LIABILITY
The manufacturer recommends using the device only under the
conditions specified and for the intended purposes. The device must be
maintained according to the instructions for use. The manufacturer is
not liable for damage caused by component combinations that were not
authorized by the manufacturer.
COMPLIANCE
This device has been tested according to ISO 10328 standard to two
million load cycles. Depending on the user's activity this corresponds to
a duration of use of two to three years. We recommend carrying out
yearly safety checks. This device has been tested for moderate impact
ISO - "P" - "m"kg *)
*) Body mass limit not to be exceeded!
For speci c conditions and limitations of use see
manufacturer's written instructions on intended use!
mass. In these cases, the test loads have been adapted adequately on the
basis of the specified load level.
Category
1
2
3
4
5
6
WARRANTY
Össur provides a warranty of 24 months for the device, and 6 months for
the foot cover.
ISO 10328 - label
Weight (Kg)
52
59
68
77
88
100
level use. Refer to category
selection chart for low impact
level use. In the standard
mentioned, test levels (P) are
assigned to certain maximal
body masses (m). In some
cases, which are marked with*),
no test level is assigned to the
device related to maximal body
Label text
ISO 10328–P3–52–kg
ISO 10328–P3–59–kg
ISO 10328–P3–68–kg
ISO 10328–P4–77–kg
ISO 10328–P4–88–kg
ISO 10328–P5–100–kg
9