Walkers - Rp758S - Mopedia RP755S Manual De Instrucciones

8.2 Walkers – RP758S
1. Open the frame as in pic. (1.) Pay attention that safety buttons correctly block the sides of the
walker, as in pic. (2 and 3.) Then, insert safety clips in the holes in the rear part of the walker as in
pic. (4).
(1)
2. Connect legs with wheels to the frame (legs with brakes must be on the back). Safety buttons
have to click when they are blocked.
NOTE Legs have to be all at the same height. Pic. (5)
3. Place the handles in the tubes and block them with lever. Pic. (6)
NOTE If levers can not tighten enough the tube, tighten the screw nut.
(5)
RP757
How to fold the walker:
1. Remove the seat.
2. Remove safety clips
3. Press the safety buttons in the front and in the rear part as in pic. (9-10) and fold the four
parts inward. Pic. (11-12)
(9)
(2)
(6)
4. Insert shoulder support tubes from the longer side, in the holes
pic. (7) and block them with levers.
5. Insert the shoulder supports in the tubes. Pic. (8)
6. Adjust the height of the walker following the indication of the patient.
The seat can easily be installed in the walker thanks to 4 hooks.
*(RP757 optional)
(10)
(3)
(7)
(11)
(12)
7
(4)
(8)