Technical Data; Inserting/Replacing The Battery; Initial Operation - CST/BERGER LASERMARK LM2 Manual Del Usuario

Tabla de contenido

Publicidad

OBJ_BUCH-930-002.book Page 15 Tuesday, February 24, 2009 1:49 PM

Technical Data

Tile laser
Working range
Operating temperature
Measuring accuracy over 1 m
Laser class
Laser type
Batteries
Weight according to EPTA-Procedure
01/2003
Degree of protection
Assembly

Inserting/Replacing the Battery

Alkali-manganese batteries are recommended for the measuring tool.
Remove the batteries from the measuring tool when not
using it for extended periods. When storing for extended periods,
the batteries can corrode and discharge themselves.
When inserting batteries, pay attention to the correct polarity according
to the representation on the inside of the battery compartment.
Always replace all batteries at the same time. Only use batteries from
one brand and with the identical capacity.
Operation

Initial Operation

Protect the measuring tool against moisture and direct sun
irradiation.
1 609 929 T58 • 24.2.09
0 – 30 m
0°C – 40°C
± 0.3 mm/m
3 x 1.5 V (AA)
IP 55 (protected against
debris, dust and splash water)
English | 15
LM2
2M
635 nm
0.5 kg

Publicidad

Tabla de contenido
loading

Tabla de contenido