Product Specifications - Home2O H04L-821-CH Manual De Instrucciones

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 1.2 GPM (4.54 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Polished chrome, brushed nickel or oil rubbed bronze finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Place the spout ssembly (1) through
the mounting hole in sink. Secure the
spout assembly (1) with the washers
(2) and nut (3).
NOTE: Ensure that the hole for the
lift rod faces toward the rear of the
sink during installation. When you
insert the lift rod, the lift rod can go
through the spout assembly (1) and
down into the slot of the washers (2).
3. Slide the hot and cold end valves
(1 & 2) through the sink mounting
holes. Make sure the long tubes are
installed away from the spout assembly
(3). Secure the end valves (1 & 2) with
the washers (4) and nuts (5). Hand
tighten the nuts (5) onto the end
valve (1 & 2) shanks. Lock the nuts
(5) into position by tightening the
screws (6) with a Phillips screwdriver.
NOTE: The hot side end valve is
labeled.
4. Align the tabs (1 & 2) on the quick
connect assembly (3). Push the quick
connect assembly (3) firmly upward
and snap it onto the receiving tube
tab. Pull down moderately to ensure
the connection has been made. If
it is necessary to remove the quick
connect assembly (3), squeeze the
tabs on the hose, and then pull down
to disconnect.
1
2
1
2
3
3
3
1
4
5
6
4
1
3
2
Ceramic cartridges
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
Make Connections to
5.
Water Lines:
Use 1/2 in. I.P.S. faucet connections
(2), or use supply line coupling nuts
(3) (not included) with a 3/8 in. O.D.
ball-nose riser (1). Before tightening
the faucet connector to the water
supply, apply a second wrench to
the supply tube fitting. This will
prevent the supply tube from
moving or twisting when tightening
the faucet connector.
Do not overtighten.
6. Remove the stopper (1) and the
flange (2). Screw the nut (3) all the
way down, and push the gasket (4)
down.
7. Apply silicone to the underside of
the flange (1). Insert the pop-up
2
body (2) into the sink. Screw the
flange (1) onto the pop-up body
(2). The pivot hole (3) must face
the back of the sink. Use the
groove joint pliers to tighten the
nut (4), but do not over tighten.
Do not turn the pop-up body (2)
while tightening the nut (4) or the
sealant may not seal properly.
Clean away any excess putty.
8. Remove the pivot nut (1). Install
the horizontal rod (2) and the
stopper (3), as shown (4). Hand
tighten the pivot nut (1). Attach the
horizontal rod (2) to the strap (5)
using the clip (6).
2
SPECIFICATIONS
5
1
2
3
6
4
3
7
4
8
3
2
4
www.homewerksww.com
1
2
1
3
2
5
6
1