Product Specifications - Home2O H60K-51D-CH Manual De Instrucciones

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 1.8 GPM (6.814 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Polished chrome, brushed nickel or oil rubbed bronze finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
Optional Deck Plate
2.
installation:
Fit gasket onto bottom of deck plate.
3. Position faucet assembly over sink
top, carefully feeding supply tubes
through the hole in the sink. Make
certain the supply hose indicated
HOT is positioned on the left side.
Position the swivel spout and handle
so that they are properly centered
over the sink thread mounting bolts
to bottom of deck plate through
key-hole slots located on gasket.
Slide cover plate onto bottom of
faucet. Secure with rubber washer
and locknut. Attach faucet assembly
to sink by threading on plastic wing
nuts and tightening. PROCEED TO
STEP 6.
Optional Flange Installation:
4.
Install collar to faucet.
www.homewerksww.com
1
2
3
HOT
4
Ball control cartridge
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
Total weight of item: 3.90 lbs.
5. Position faucet assembly over sink
top, carefully feeding supply hoses
through hole in sink. Make sure the
supply hose indicated HOT is
positioned on left side. Position
swivel spout and handle so that
they are properly centered over
sink. Place rubber washer and
thread locknut onto mounting body
and tighten locknut with supplied
socket wrench.
6. After inserting the hose (1)
through the hole in the sink
surface, retract the hose (1) back
down, and reattach the quick
connector (2) by screwing it into
the end of the hose (3) in a
clockwise motion. Hand tighten
only.
7. Push the quick connector (1)
firmily upward and attach it to the
receiving block (2). Pull down
moderately to ensure the
connection has been made. If it is
necessary to remove the quick
connector (1), squeeze the tabs on
the hose (3) and then pull down to
disconnect.
8. After connecting the hose install the
weigh (1) at the point of the hose
marked "weight here" (2). Attach
weight to the sprayer hose by plac-
ing the two halves together using
the 2 screws provided. Adjust the
position of the weight as desired to
prevent hose kinking and to facilitate
hose retraction.
2
SPECIFICATIONS
5
HOT
6
2
3
1
7
8
2
1
2
1
3
1