Display Brightness - Teac NR-7CD Manual Del Usuario

Settings (continued)
DSD digital filter
This sets the type of digital filter used when converting DSD signals
from digital to analog .
*DSD D-FILTER
> CUTOFF 150kHz
CUTOFF 50kHz
50kHz cutoff frequency
CUTOFF 150kHz
150kHz cutoff frequency

Display brightness

This sets the brightness of the display .
o Regardless of the brightness setting, however, error messages
will always be shown at normal brightness .
*DIMMER
> DIMMER 3
DIMMER 3
Normal brightness
DIMMER 2
Slightly dim
DIMMER 1
Even dimmer
DIMMER 0
Unlit
o The display stays unlit even when the unit is on .
26
Level meter operation
This sets level meter brightness and turns operation on and off .
*METER
> DIM3
DIM3
Level meter brightness: bright
Level meter operation: on
DIM2
Level meter brightness: slightly dim
Level meter operation: on
DIM1
Level meter brightness: even dimmer
Level meter operation: on
DIM0
Level meter brightness: unlit
Level meter operation: on
OFF
Level meter brightness: unlit
Level meter operation: off
Automatic power saving function
This unit has an automatic power saving function .
o The automatic power saving function is on when the unit is
shipped new from the factory .
*AUTO POWER SAVE
> ON
OFF
The automatic power saving function is disabled .
ON
If no audio is played back for about 30 minutes, the unit will
automatically enter standby mode .
o Even when audio is playing back, automatic power saving will
also function if the VOLUME knob is set to a value at which
sound cannot be heard .