Before Use; Maintenance; Using The Remote Control; Installing Batteries - Teac NR-7CD Manual Del Usuario

V
Placement precautions
o Do not install this unit in a location that could become hot .
This includes places that are exposed to direct sunlight or near
a radiator, heater, stove or other heating equipment . Moreover,
do not place it on top of an amplifier or other equipment that
generates heat . Doing so could cause discoloration, deformation
or malfunction .
o When installing this unit, leave a little space (at least 3 cm or 1")
between it and walls and other devices in order to allow good
heat dissipation .
If you put it in a rack, for example, leave at least 5 cm (2") open
above it and at least 10 cm (4") open behind it .
Failure to provide these gaps could cause heat to build up inside
and result in fire .
Note about pinpoint feet
High-precision metal pinpoint feet are attached firmly to the bot-
tom plate of this unit .
The stands for these feet are loose, but when the unit is placed in
position, it is supported by these pinpoint feet, which will effectively
disperse vibrations .
Chassis
Foot-stand (metal)
o The included felt pads are intended to protect the surface where
the unit is placed . Apply them to the bottoms of the foot-stands .
Wipe dirt from the top cover and other panel surfaces using a
soft cloth that has been slightly dampened with a diluted neutral
cleanser .
Do not wipe with chemical cleaning cloths, thinner or other chemi-
cal agents . Doing so could damage the surface .
V
For your safety, disconnect the power cord from
the outlet before cleaning.

Before use

Pinpoint foot (metal)
Screws that attach
foot-stand

Maintenance

Using the remote control

Precautions for use
V Misuse of batteries could cause them to rupture or
leak, which might result in fire, injury or the stain-
ing of nearby materials. Please carefully read and
observe the precautions on page 3.
o When using the remote control, point it toward the remote con-
trol signal receiver on the main unit from a distance of 5 m (16 ft)
or less . Do not place obstructions between the main unit and the
remote control .
o The remote control might not work if the remote control signal
receiver on the unit is exposed to direct sunlight or bright light . If
this occurs, try moving the unit .
o Beware that use of this remote control could cause the unin-
tentional operation of other devices that can be controlled by
infrared rays .

Installing batteries

Remove the cover from the back of the remote control and insert
two AAA batteries with their ¥/^ oriented as shown in the case .
Replace the cover .
When to replace batteries
If the distance required between the remote and the main unit
decreases or if the unit stops responding to the remote buttons,
replace both batteries with new ones .
Dispose of the used batteries according to the instructions on them
or requirements set by your local municipality .
EN
7