Discs; Handling Discs - Teac NR-7CD Manual Del Usuario

Discs

The following marks appear on disc labels and disc cases . This unit
can play discs that have these marks without using an adapter .
This unit cannot play discs that do not have these marks .
Types of discs that can be played on this unit and
their marks
CDs with the "COMPACT disc DIGITAL AUDIO" logo (12 cm,
8 cm)
o This logo appears on disc labels and packages .
If you try to play any other type of disc with this unit, loud
noises that could damage speakers or harm hearing might
occur. Never try to play any type of disc other than those
shown above.
o This unit cannot play DVD video, DVD audio, video CD, DVD-ROM
and CD-ROM discs, for example .
o This unit might not be able to properly play Dual Discs, Copy
Control CDs or other special CDs that do not conform to the
Red Book CD standard . Operation and sound quality cannot be
guaranteed when special discs are used in this unit . If playback of
a special disc should cause trouble, contact the seller of the disc .
CD-R/CD-RW discs
This unit can play CD-R/CD-RW discs that are in audio CD format .
o Be sure to finalize discs created by CD recorders .
Depending on the quality of the disc and the condition of the
recording, playback might not be possible. For details, see
the operation manual for the device you are using.

Handling discs

o Load discs with their labeled sides up .
(CDs only have one playable side . )
o To remove a disc from its case, always press down on the center
of the case first and then hold the disc by its edges .
Removal from case
o Be careful when handling discs . If the side that contains the data
(unlabeled side) is scratched, smudged with fingerprints or oth-
erwise dirty or marred, errors could occur during playback .
8
Holding by edges
o If the side of the disc that has the data encoded on it (unlabeled
side) becomes dirty with fingerprints or dust, use a soft cloth to
wipe the surface from the center directly toward the edge .
Always clean discs before storing them . Leaving a disc in an
unclean state might degrade its sound quality .
o Never use record cleaners, antistatic treatments, thinners or
similar chemicals to clean discs . Such chemicals could harm the
surface of the disc .
o Do not leave discs in places that are exposed to direct sunlight or
that are very humid or hot .
o When writing something on the label side of a disc, use a felt tip
permanent marker . The use of a ballpoint pen or other pen with
a hard tip could damage the disc, making it unplayable .
o After you finish playing a disc, always put it back into its case for
storage . Failure to do so could result in warping and scratches .
o Do not apply labels or other materials to discs . Do not use a disc
that has sticky residue left on its surface after removing tape or
a sticker, for example . If such a disc is loaded, it might become
stuck in the unit or damage the unit .
o Never use commercially-available CD stabilizers . Doing so could
make the disc unplayable or damage the unit .
o Do not use cracked discs because they could damage the unit .
o Never use discs with irregular shapes, including heart-shaped
and octagonal discs, because they could damage the unit .
o Do not use printable discs, which allow printing on the label
side . Since the surface of such a disc has been specially treated,
if loaded, it might become stuck in the unit or damage the unit .
If you have any questions about how to handle a CD-R or CD-RW
disc, contact the manufacturer of the disc directly .