Problem Identification - Stiga Cruiser 430 Li 80 Serie Manual De Instrucciones

Check the rear discharge
/ side discharge guards.
Check the grass catcher,
side discharge chute.
Check the cutting means
Check the battery
charge status
Recharge the battery
General cleaning
and inspection
Checking for any damage to
the machine. If necessary,
contact the authorised
service centre.
Cleaning the air filter
Drive adjustment
Replacing the cutting-means
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Service Centre
*** Operation to be performed at the first signs of any malfunction

14. PROBLEM IDENTIFICATION

If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. The motor does not
start when the switch
is pressed (type "I"
handle).
2. When pressing the
power button, the
display does not turn
on (type "II" handle -
Advanced Series).
3. When pressing the power
button, the display does
not turn on and the ma-
chine emits an acoustic
buzzer (type "II" handle
- Advanced Series).
The motor is running but
4.
the cutting means is sta-
tionary (type "I" handle).
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
Once a month
***
-
PROBABLE CAUSE
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is
inserted incorrectly.
Low battery.
Motor start-up is slow.
The thermal protection has tripped
due to overheating of the motor.
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is
inserted incorrectly.
Internal motor anomaly.
The cutting means fittings are loose.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Check the battery status and recharge
if necessary (par. 7.2.3).
Press and hold the control lever
for 1-3 seconds (par. 5.2).
Wait for at least 5 minutes and
then restart the machine.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Remove the safety key and contact
the Technical Assistance Centre for
checks, replacements or repairs.
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 8.1).
EN - 13
par. 6.2.1
par. 6.2.1
par. 6.2.1
*
par. 7.2.3 *
par. 7.3
-
par. 7.5
par. 7.6
par. 8.1 ***
SOLUTION