YATO YT-09955 Manual De Instrucciones página 14

Wipe off any excess oil that may have escaped through the outlet openings. The oil left can damage the tool seals.
Other maintenance activities
Before each use of the tool, make sure that there are no signs of damage to the tool. Keep drivers, tool holders and spindles clean.
Have the tool inspected by a qualifi ed workshop personnel every 6 months or after 100 operating hours. If the tool has been used
without the recommended air supply, increase the inspection intervals of the tool.
Removing defects
Stop using the tool as soon as you detect any defect. Use of a defective tool may result in injury. Any repairs or replacements to
the tool components must be carried out by qualifi ed personnel at an authorised repair shop.
Defect
The tool rotation is too slow
or does not start up.
The tool starts up and then
slows down
Insuffi cient power
Spare parts
For a detailed list of spare parts for the appliance go to the "Download" section in the Product tab on the TOYA SA website:
www.toya.pl.
After work has been fi nished, clean the housing, ventilation slots, switches, additional handle grip and guards using e.g. a jet of
air (pressure not more than 0.3 MPa), or a brush or dry cloth without the use of chemicals or cleaning liquids. Clean the tools and
holders with a clean, dry cloth.
Used tools are recyclable materials - they cannot be thrown into household waste containers as they contain substances dan-
gerous to human health and the environment! Please actively help us to conserve natural resources and protect the environment
by handing over used equipment to a waste equipment storage point. In order to reduce the amount of waste disposed of, it is
necessary to reuse, recycle or recover it in another form.
O R I G I N A L
14
Possible solution
Apply a small amount of WD-40 through the air inlet opening. Activate the tool for a few seconds. The blades could stick to the rotor.
Activate the tool for approx. 30 seconds. Lubricate the tool with a small amount of oil. Caution! Excess oil can cause the tool to lose
power. In this case, clean the drive.
The compressor does not provide an adequate supply of air. The tool is activated by the air accumulated in the compressor tank. As the
tank empties, the compressor does not keep up with fi lling in the air shortages. Connect the device to a more effi cient compressor.
Make sure that the hoses have an internal diameter at least as specifi ed in the table in item 3. Check the pressure setting to ensure that
it is set to the maximum value. Make sure that the tool is properly cleaned and lubricated. If there are no results, have the tool repaired.
GB
I N S T R U C T I O N S