VALBERG SBS 578 WD F DX180C Instrucciones De Uso página 47

B
• Before using
The following steps should be taken before using this appliance for the first time.
1. Hold one side of the bottom of the water tank with one hand and lift up the opposite side
with the other. When the water tank slot has been removed from the guide, change hands
and repeat these steps.
2. Hold both sides of the water tank tightly, lift and remove the water tank.
3. Unscrew the head and clean the head, lids and water tank.
WARNING:
Drain the water tank before removing it.
• Assembling
After cleaning, assemble the parts including the head, water tank and lids as follows:
1. Install the seal ring first (the seal ring must not face upwards), then insert the head into the hole.
2. Hold both sides of the water tank tightly, fit the water tank along the guides on the door.
3. Push both sides of the water tank downwards as shown in the picture.
4. Installation is complete when you hear clicks on both sides and at the same time both sides
of the water tank are close to the door liner.
Using the appliance
41
guide
head slot
EN