Consumer Information - Moen 7700 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FAUCET FLUSHING
IMPORTANT: Pipe chips, sand, stones and other solids found in
new and renovated plumbing can damage the sealing surfaces of
the cartridge and cause leaks. To avoid damage, DO NOT TURN
ON SUPPLY VALVES until instructed below.
1.
After installing and connecting your new faucet, make sure that
the handles are in the on or open position (rotate cold handle in
the clockwise direction and hot counter clockwise).
2.
Open hot and cold water shut off valves and
allow the water to run for 15 seconds.
3.
Turn both handles to the off or closed position. Unscrew the
aerator, by hand, from the end of spout and clean any debris
from the aerator screen.
4.
Replace the aerator and check system for leaks.
DISASSEMBLY
CAUTION: Always turn water OFF
before removing or disassembling the
valve. Open valve handles to relieve water
pressure to insure that complete water
shut-off has been achieved.
1.
Holding the lever (1) or cross (10) handle with one hand, unscrew
the handle hub (4)counterclockwise as shown above and set aside.
2.
Place the cartridge removal tool (39) (not included) into the slots of the cartridge nut and unscrew counterclockwise.
3.
Grasp the stem extension with pliers as shown above and pull straight up.
This will remove the stem extension and cartridge as one unit.
4.
To reassemble, reverse previous steps. Turn cartridge stems to ON position, while holding the cartridge, turn the hot side stem
extension (red) counterclockwise, and the cold side stem extension (blue) clockwise. Push stem extension and cartridge straight
down into body and rotate clockwise until you feel key enter notch in the valve body. This will correctly position the cartridge.
Turn stem extensions in both directions to insure a stop in each direction. Replace cartridge nuts, start by hand DO NOT
CROSS THREAD, and tighten firmly.
CAUTION: Be careful not to damage the rubber seals on the cartridge when re-installing cartridge.
WARRANTY
Moen products have been manufactured under the highest standards of quality and workmanship. Moen
warrants to the original consumer purchaser for as long as the original consumer purchaser owns their home
(the "Warranty Period" for homeowners), that this faucet will be leak and drip-free during normal use and all parts
and finishes of this faucet will be free from defects in material and manufacturing workmanship. All other purchasers
(including purchasers for industrial, commercial and business use) are warranted for a period of 5 years from the
original date of purchase (the "Warranty Period" for non-homeowners).
If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF CHARGE provide
the parts necessary to put the faucet back in good working condition and will replace FREE OF CHARGE, any part or
finish that proves defective in material and manufacturing workmanship, under normal installation, use and service.
Replacement parts may be obtained by calling 1-800-289-6636, or by writing to the address shown below. Proof of
purchase (original sales receipt) from the original consumer purchaser must accompany all warranty claims. Defects
or damage caused by the use of other than genuine Moen parts are not covered by this warranty. This warranty is
applicable only to faucets purchased after December 1995 and shall be effective from the date of purchase as shown
on purchaser's receipt.
This warranty is extensive in that it covers replacement of all defective parts and finishes. However, damage due
to installation error, product abuse, product misuse, or use of cleaners containing abrasives, alcohol or other organic
solvents, whether performed by a contractor, service company, or yourself, are excluded from this warranty. Moen
will not be responsible for labor charges and/or damage incurred in installation, repair or replacement, nor for any
indirect, incidental or consequential damages, losses, injury or costs of any nature relating to this faucet. Except as
provided by law, this warranty is in lieu of and excludes all other warranties, conditions and guarantees, whether
expressed or implied, statutory or otherwise, including without restriction those of merchantability or of fitness for use.
Some states, provinces and nations do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights
and you may also have other rights which vary from state to state, province to province, nation to nation. Moen will
advise you of the procedure to follow in making warranty claims. Simply write to Moen Incorporated using the address
below. Explain the defect and include proof of purchase and your name, address, area code and telephone number.
3
Moen Incorporated 25300 Al Moen Drive, North Olmsted, OH 44070-8022 U.S.A. in Canada: Moen Inc. 2816 Bristol Circle, Oakville, Ontario L6H5S7
In the U.S., call our toll free Helpline number for answers to any
product installation or warranty questions.
1
2
39
1
4

CONSUMER INFORMATION

Faucets made of leaded brass alloys may contribute small amounts
of lead to water that is allowed to stand in contact with the brass.
The amount of lead contributed by any faucet is highest when the
faucet is new. The following steps may reduce potential exposure
to lead from faucets and other parts of the plumbing system:
• Always run the water for a few seconds
• Use only cold water for drinking or cooking
• If you wish to flush the entire plumbing system of water
• If you are concerned about lead in your water,
This faucet has been tested under actual operating conditions
and complies with flow restrictions for water usage as set by
the Federal Trade Commission.
Questions,
Comments?
Call Moen!
1 (800) BUY-MOEN
[289 - 6636]
In Canada:
Toronto: 905-829-3400;
Rest of Canada: 1-800-465-6130
In Mexico:
(84) 88-08-26, 88-08-27,
o 91-800-84-345
PLEASE HAVE THE FOLLOWING INFORMATION
AVAILABLE WHEN CALLING OUR MOEN HELPLINE:
• Faucet Model Number
• Faucet Finish
• Date and Location of Faucet Purchase
3
STEM
EXTENSION
12
13
prior to use for drinking or cooking
that has been standing in the pipes or other fittings, run
the cold water until the temperature of the water drops,
indicating water coming from the outside main
have your water tested by a certified laboratory in your area
4
STEM
EXTENSION
KEY
INS163C

Publicidad

Tabla de contenido
loading

Tabla de contenido