Rotisserie Kit Assembly; Important Safety Instructions - Costco RC3218 Instrucciones De Ensamble Y Cuidado

Rotisserie Kit Assembly

To use the rotisserie: Assemble the rotisserie kit as shown in the figure below. The rotisserie rod should be assembled
into the motor by placing the pointed end into the motor, and then sliding the shaft sleeve into the slot at the opposite
side of the grill.
Note:
1 Do not use main burners or searing burner or side burner when the rotisserie kit is installed.
2. When using the rotisserie kit, remove the warming rack. Otherwise, the kit will be damaged.
3. The main cooking grids can be removed to provide more space for rotisserie.
The rotisserie motor instructions
The motor power input: 120V ~ 60Hz 4W
The rotisserie motor is capable of turning up to a 4.5kg/ 9.92 lb. cut of meat or poultry. The motor slides onto the
motor bracket.
The rotisserie motor must be electrically grounded in accordance with local codes, or National Electrical Code, ANSI /
NFPA 70 or Canadian Electrical Code, CSA C22.1.
Warning:
To protect against electrical shock, do not immerse electrical cord, plugs or motor in water or expose to rain.
Protect electrical elements from burners, hot grill surfaces and grease.
To protect against shock hazard risk. Connect only to properly grounded outlet.
This power supply cord has a 3-prong grounding plug for your personal safety. It must be plugged into a mating
3-prong grounding type receptacle, grounded in accordance with the national electrical code and local codes and
ordinances. Store products indoors when not in use - out of children.
To ensure continued protection against risk of electrical shock, connect to properly grounded outlets only. If an
extension cord is used, it must be properly grounded and suitable for used with outdoor appliances, keep extension
cord connection dry and off the ground. When rotisserie is not in use, remove and store in a dry area.

IMPORTANT SAFETY INSTRUCTIONS

When using electrical products, basic precautions should always be practiced including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2. Read and follow all instructions that are on the product or provided with the product.
3. Reference the National Electrical Code, ANSI/NFPA 70, specifically for the installation of wiring and clearances
from power and lighting conductors.
4. Do not install or use within 10 feet of a pool.
5. Do not use in a bathroom.
6. WARNING: Risk of Electric Shock. When used outdoors, install only to a covered Class A GFCI protected
receptacle that is weatherproof with the power unit connected to the receptacle. If one is not provided, contact a
qualified electrician for proper installation. Ensure that the power unit and cord do not interfere with completely
closing the receptacle cover.
7. For a unit intended to be mounted greater than 0.30 m (1 foot) from the ground surface:
WARNING: Risk of Electric Shock. Mount the unit at a height greater than 1 foot from the ground
surface.
8. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for power
units.
20