Candulor CRS SET 10 Instrucciones De Uso página 18

5. Mark one point on the patient's chin and nose tip and
measure the resting balance position with the Sliding
C aliper. The patient must sit upright and keep his/her
straight for bite registration.
6. The mandible template fabricated in the laboratory is
placed in the mouth and checked to ensure it fits properly.
Here, the wax wall height should match up with the equa-
tor of the tongue.
7. Check the position of the wax wall templates with
respect to each other as well as the vertical height. It
should be 2 - 3 mm lower than the relaxed rest position.
Drawing the center line on the maxilla.
34
8. Using these measurements, it is recommend making a
temporary articulation of the model.
9. The mandible registration plate is fixed to the occlusal
level and notches are made in the wax wall to aid keying
(Fig. 1).
EN
Fig. 1
35