To Adjust The Harness; To Put The Product In Transportation Mode; Operation; To Connect The Battery To The Product - Husqvarna 340iBT Manual Del Usuario

9. Connect the intermediate pipe (L) to the joint swivel
(F). Make sure that the knob (I) aligns with the
guide track of the intermediate pipe.
L
F
I
10. Turn the intermediate pipe (L) fully to lock the joint
swivel (F) and the intermediate pipe.
11. Connect the blow pipe (M) to the intermediate pipe
(L). Make sure that the knob (N) on the
intermediate pipe points up and goes into the guide
track of the blow pipe.
12. Turn the blow pipe fully to lock the intermediate
pipe and the blow pipe.
13. Attach the cable clamp to the flexible tube. Put the
cable of the operation handle in the loop on the
cable clamp.
.
Introduction
WARNING:
understand the safety chapter before you
use the product.
10
M
N
Read and

To adjust the harness

Adjust the harness to give the best operation position.
1. Put on the harness of the product.
2. Tighten the shoulder straps (B) until the harness is
tight against your body.
3. Connect the chest strap to the clip (A).
4. Tighten the chest strap.
To put the product in transportation
mode
1. Turn the blower tube until it points up.
2. Connect the transport clip.

Operation

To connect the battery to the product

WARNING:
Husqvarna original batteries in the product.
1. Make sure that the battery is fully charged.
A
B
Only use
1166 - 007 - 30.06.2020