Moretti MOPEDIA NEFTI BI100 Manual Del Usuario página 32

12
Voltage drop outs,
brief interruptions and
variations of voltage on
the power supply lines.
IEC 61000-4-11
Mains frequency magnetic
field (50/60 Hz)
IEC 61000-4-8
Note: UT is the AC mains voltage prior to application of the test level.
Table 3
Manufacturer's guide and declaration - electromagnetic immunity
The NEFTI device is intended to be used in the following electromagnetic conditions. The client or
user must ensure that it is used in these conditions. Make sure it is used in these conditions.
Immunity tests
conducted RF
IEC 61000-4-6
radiated RF
IEC 61000-4-3
<5% UT
(>95% UT drop out)
for 0.5 cycles
40% UT
(60% UT drop out)
for 5 cycles
70% UT
(30% UT drop out)
for 25 cycles
<5% UT
(>95% UT drop out) for 5 s. (>95% UT drop out) for 5 s.
3 A/m
Test level IEC 60601
3 V eff.
From 150 KHz to 80 MHz
3 V/m
From 80 MHz to 2.5 GHz
<5% UT
(>95% UT drop out)
for 0.5 cycles
40% UT
The quality of the mains
(60% UT drop out)
supply must be that of a
for 5 cycles
typical commercial hospital
70% UT
when charging the battery.
(30% UT drop out)
for 25 cycles
<5% UT
Power frequency magnetic
levels characteristic of
a typical location in a
3 A/m typical commercial or
hospital environment.
(Applies both to using
the device and charging
Conformity level
environment – guide
Portable and mobile
3 V eff.
RF communications
equipment should be used
no closer to any part of
the [equipment or system],
including cables, than the
recommended separation
distance calculated from
the equation applicable
separation distance:
from 80 MHz to 800 Mhz
from 800 MHz to 2,5 GHz
during recharge operation
3 V/m
where "P" is the maximum
output power rating of
the transmitter in watts
(W) according to the
transmitter manufacturer
and "d" is the raccomended
separation distance
in metres (m). Fields
strenghts from fixed RF
transmitters, as determined
by an electromagnetic
site survey, should be
less than the compliance
level in each frequency
range. Interference may
occur in the vicinity of
equipment marked with
the following symbol:
fields should be at
the battery).
Electromagnetic
to the frequency of
the transmitter.
Recommended
d = 1,2√P
d = 1,2√P
d = 2,3√P
d = 7,7 m