Installing And Connecting The Dc Kit - Waeco DC-Kit3 Instrucciones De Montaje Y De Uso

DC-Kit3.book Seite 27 Freitag, 13. Juni 2008 3:24 15
DC-Kit3
The MSK1500-012 inverter supplies the roof air conditioner with the re-
quired input voltage of 230 V~. The inverter generates the 230 V input
voltage from the 12 V on-board electricity supply in the vehicle.
The MCR9 remote control can switch the inverter on and off.
The VS-230-2 priority circuit can be used for distributing the voltage in the
vehicle with two available power sources. If a mains voltage and voltage
created by the inverter (vehicle battery) are both connected to the device,
the use of the mains voltage has priority. If the only voltage available is
that generated by the inverter, the power supply from the battery is used.
This ensures that the limited power of the battery is not used unnecessar-
ily.
7

Installing and connecting the DC kit

a
Caution!
The DC kit may only be installed by a qualified workshop.
The following information is intended for specialists who are famil-
iar with the guidelines and safety precautions to be applied.
a
Caution!
Observe the information in the installation and operating manuals
when installing the components supplied
MSK1500-012 inverter
MCR9 remote control
VS-230-2 priority circuit
ECL-102 charging current distributor
and for your Dometic roof air conditioner
CA1000
CA2500
B1600
B2200
HB2500
Installing and connecting the DC kit
27