Switching Off The System; Maintaining And Cleaning The Dc Kit; Rectifying Faults - Waeco DC-Kit3 Instrucciones De Montaje Y De Uso

DC-Kit3.book Seite 35 Freitag, 13. Juni 2008 3:24 15
DC-Kit3
B1600, HB2500
If the charging voltage regulator cuts the connection to the supply battery
due to low voltage, it switches off the inverter at the same time using the
MCR9 remote control. There is no voltage in the socket for the inverter.
As soon as the voltage in the supply battery reaches the switch-on point
in the charging current distributor, it restores the connection between the
starter and supply battery and switches the inverter on again using the
MCR9 remote control. There is voltage in the socket again for the
inverter.
The air conditioning starts again automatically.
If the voltage in the supply battery drops further and goes below the
10.5 V switch-off point for the inverter, the inverter switches off (chapter
"Driving mode: power supply from the 12 V battery with motor switched
off." on page 33).
8.2

Switching off the system

➤ First of all, switch off the air conditioning.
➤ If there are no more consumer units which need power, switch off the in-
verter using the MCR9 remote control.
9

Maintaining and cleaning the DC kit

I
Note
Observe the maintenance and cleaning instructions in the operat-
ing manuals of the individual components.
➤ Check the power supply lines for abrasion or defects regularly.
➤ Have the system checked regularly by a specialist.
➤ If you find any faulty fuses, have the system checked by a specialist.
10

Rectifying faults

I
Note
Observe the instructions on rectifying faults in the operating manu-
als of the individual components.
Maintaining and cleaning the DC kit
35