Vertilux Vti 025 Serie Manual De Programación página 7

Adding an additional remote control or
"cloning" a channel
A previously programmed remote control can be used in order to add a new remote control or
operating channel. Also, you can copy one channel to another in the same remote control using
this procedure.
1. Using the previously programmed
remote, select the desired channel using the
channel selector button, then press and hold the
stop button
for about
2.
Using the new remote, select the desired
channel using the channel selector
up button
then press the
Vertilux shades are now paired with the new
remote or channel.
Changing to tilt or jog mode
Tilt or jog mode
initiates a short motor movement when pressing the up or down buttons.
tilt or jog mode
The is convenient for Venetian Blinds, Wood Blinds and
since it allows the jogging of the slats in a more precise way. When this mode has been
up
programmed, the or
to its upper or lower limits, otherwise when you press the
short movements.
Repeat the same procedure if you want to erase the
1. Press and hold the
until the motor "jogs".
2. stop button
Release the
about 2 s. The motor will
tilt or jog mode
The has been programmed.
Vertilux
5 s until the motor "jogs".
button, and
until the motor "jogs".
down button
must be pressed for
stop button for about
and press it again for
"jog" again.
© 2021. Vertilux, Ltd. All Rights Reserved. Last revised: May 2021.
PREVIOUSLY
PROGRAMMED
REMOTE CONTROL
NEW REMOTE
CONTROL
OR CHANNEL
3 s
to make the motor move continually
up
and
tilt or jog mode.
5 s
BUTTON
Neolux
Dual Shades
®
down button
the motor will do
STOP
BUTTON
STOP
BUTTON
vertilux.com
STOP
BUTTON
UP
6