Vertilux Vti 025 Serie Manual De Programación página 8

Deleting a single motor or channel
This is a convenient feature when there has been a programming mistake and it is required to
delete the programming from a single channel. Also if you want to delete a programmed motor in
a single channel, put all motors previously programmed in this channel into sleep mode, except
the one you want to delete and follow this procedure.
1. Select the desired channel using the
channel selector button, and press and hold the
stop button
for about
2. Press and hold the
2 s until the motor "jogs". The selected
about
channel has been deleted. Motors previously
linked to this channel are not linked anymore.
Deleting all channels
This is needed when there has been a programming mistake and the remote control needs to be reset.
Make sure that all the motors linked to this remote control are not in "sleep mode".
1. Press and hold the
until the motor "jogs".
2. Press and hold the
about 7 s. The motor will "jog", and in a few
seconds the motor will
previous programming on the remote control has
been deleted.
Resetting the motor to factory default
METHOD A (applies to item numbers):
6-700-CM-24E04 | 6-700-CM-25E10
1. Press the programming button
head of the motor 5 consecutive times (every
time you press, the motor will "beep") and hold
the button on the fifth time until the motor
twice. All previous programming on the motor
has been deleted.
METHOD B (applies to item number):
6-700-CM-35EB6
1. Press and hold the
located on the head of the motor for about
hold the button until the motor
then "jogs" two more times. All previous
programming on the motor has been deleted.
5 s until the motor "jogs".
programming button for
stop button for about 5 s
programming button for
"jog"
two more times. All
located on the
"jogs"
programming button
7 s
"jogs"
once and
© 2021. Vertilux, Ltd. All Rights Reserved. Last revised: May 2021.
and
STOP
BUTTON
PROGRAMMING
BUTTON
STOP
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
vertilux.com
7