Section 2. 9300 Sport Specifications; General Specifications; Section 3. Assembly And Initial Usage; Unpacking - Polaris 9300 Sport Manual Del Usuario

Page 6

Section 2. 9300 Sport Specifications

2.1 General Specifications

The general specifications for the Polaris 9300 Sport are
as follows:
Control box supply voltage: 100-125 VAC, 60 Hz
Polaris 9300 supply
voltage:
Installed load:
Cable length:
Cleaner size (WxDxH):
Pack size (WxDxH):
Weight of Cleaner:
Packed weight:
Filtration capacity:
Cycle lengths:
The Polaris 9300 is a double-insulated product. A
double-insulated electrical appliance is one which has
been designed in such a way that it does not require a
safety connection to ground. The basic requirement for
double-insulation is that no single failure can result in
dangerous voltage becoming exposed so that it might
cause an electric shock and that this is achieved without
relying on an earthed (grounded) metal casing. This is
achieved by having two layers of insulating material
surrounding live parts or by using reinforced insulation.
Therefore, devices having double-insulated construc-
tion, such as the Polaris 9300, do not utilize a grounded
(three-prong) cord/plug.
Section 3. Assembly and Initial
Usage

3.1 Unpacking

The packaging should contain the following items
(Refer to Figure 1):
• 9300 Sport cleaner
• Power supply
• Transport and storage caddy (complete with
assembly components)
28 V DC
150 W max
60 feet
18 m
16.9 x 18.9 x 10.6 inches
43 x 48 x 27 cm
22.8 x 22.8 x 23.2 inches
58 x 58 x 59 cm
25 lbs
11.3 kg
42 lbs
19 kg
100 microns
1.30 hrs, 2.30 hrs
Figure 1. Polaris 9300 Sport Components
Check that the unit has not been damaged during trans-
port. If you detect damage, contact Zodiac Pool Sys-
tems, Inc. at 800.822.7933 before using your 9300 Sport
cleaner.
To unpack the 9300 Sport and its components:
1. Remove the lower portion of the caddy along with
the upper and lower power cable hooks, power
supply hook, power cable hook plate, locking
plate, nuts, bolts and screws.
2 Remove the small box that contains the power
supply.
3. Remove the handles (left and right) of the caddy,
which are located against one side of the box.
4. Remove the cleaner from the box.

3.2 Assembling the Transport Caddy

1. Position the power cable hook and power supply
hook on the upper tubes as shown in Figure 2.
Make sure the upper tubes (handles) are in the
proper orientation.
!
1
Figure 2. Install hooks on the Upper handles
X4
X1
X4
X2
X2
X1
X1
X1
2