Rear Panel - SWR Sound Strawberry Blonde II Instrucciones De Funcionamiento

N . TWEETER—Switches the high-frequency speaker
ON, OFF or –dB reduced outut.
O . IEC POWER CORD SOCKET—Connect the included
power cord to a grounded AC electrical outlet in
accordance with the voltage and frequency ratings
specified on the rear panel of your amplifier.
P . EXTENSION SPEAKER—You can connect an exter-
nal speaker cabinet here if desired. The cabinet
must be Ω minimum and be able to handle
 watts minimum. Read Speaker Guidelines on the
next page before plugging anything into this jack.
Q . TUNER SEND—Plug in your guitar tuner here to
enable inline tuning. Use MUTE {A} to disable audio
output while tuning.
R . BALANCED (XLR) OUTPUT—A true electronically
balanced output, suitable for studio and "front-of-
house" (live) mixing consoles. Wiring for this jack is
the "American Standard."
8

Rear Panel

S . EFFECTS SEND / RETURN—Multi-purpose jacks.
◊
EFFECTS SEND provides a preamp output signal
that includes onboard tone shaping; output level is
primarily controlled by GAIN {D}. EFFECTS RETURN
provides a power amp input that can be blended
in any ratio with the onboard preamp signal using
EFFECTS BLEND {I}.
The Effects Loop circuit is on a "side chain" of the
main circuit (as in studio recording consoles) to
provide the full sound of your instrument AND the
diversity of your effects units. This also reduces
noise from effects units by being located after gain
in the signal path.
 . EFFECTS LOOP—Connect EFFECTS SEND to your
effects device input and the effects device out-
put to EFFECTS RETURN. NOTE: Set the wet/dry
control on external effects units to the fully WET
position to prevent phasing problems. Set the
input level on external effects as close to dB as
possible.
 . MULTIPLE AMPS—Connect the primary unit's
EFFECTS SEND to the auxiliary unit's EFFECTS
RETURN. The primary unit is used to control the
auxiliary unit, except for its MASTER Volume.
Set EFFECTS BLEND on the auxiliary unit fully to
WET.
 . RECORDING OR REINFORCEMENT—Connect
EFFECTS SEND to your sound reinforcement input
jack to use as an unbalanced LINE OUT.
 . ACCOMPANIMENT—Connect a CD player or
drum machine to EFFECTS RETURN. Control the
input level at its source and by using the EFFECTS
BLEND {I} control.
◊