Jacuzzi THE ESSENTIALS BALI Manual Del Usuario página 38

Changing the temperature
unit of measure
(only Bali hammam model)
Activating the fan
Scale removal cycle
(only Bali hammam model)
Instructions
any excess liquid is discharged throu-
gh the drain and the steam dispenser
if the LED continues to flash this
means that there is no water: check
that the supply tap is not closed.
In any case, the function is inter-
rupted if water is not available after
three minutes from turning it on
To display the temperature in degrees °C (or degrees °F, and vice versa), hold down the
button to obtain the desired display.
To turn on/off the fan, press the
The fan is located at the top of the rear panel.
It is advisable not to activate the fan during the steam bath.
To resolve any problems caused by the formation of scale in the steam generator, the shower
enclosure is equipped with a function that makes it possible to reduce the formation of any
incrustations.
To clean the steam generator, the anti-lime scale cycle must be performed
every 20-25 Turkish baths.
Prepare the anti-scale mixture (the container is not supplied) to the amount of water
indicated add the descaler specific for steam generators (for example, citric acid, refer to
the manufacturer's instructions).
Remove the protective caps and screw the tube with funnel (supplied) to the opening
indicated; then pour the descaling mixture into the steam generator.
Once the operation is terminated, remove the tube and replace the caps.
Hold down the button
control panel using the on/off button and then turn it on again, then hold down the button
until the message disappears).
Exit the shower enclosure and close the door.
The anti-lime scale cycle takes place as follows:
- filling of the steam generator (with water coming from the hydraulic system) and then
heating of the same for about one minute;
- waiting for about half an hour, in order to make the descaler act;
- heating of the liquid for half a minute and a further half-hour break;
- emptying of the steam generator (this phase lasts about three minutes);
- refilling of the steam generator and subsequent heating for about a couple of minutes;
- finally, emptying of the generator and drainage of the solenoid valve (this phase lasts for
approximately two minutes).
During the scale removal cycle, the steam or part of the boiling liquid found
in the generator could come out from the dispenser in the lower part of the
shower enclosure.
38
button (the relevant LED also turns on).
until "cL" appears on the display (otherwise, try to turn off the