Deploying The Mobile Controller In Environments With Firewalls; Installing On A Rack; Connecting The Power - Riverbed SteelHead Manual De Instrucciones

Installing SteelHead Product Family Appliances (English)

2. Deploying the Mobile Controller in Environments with Firewalls

If you need a solution for remote access users only, a location for the Mobile Controller might be in the DMZ
next to a VPN concentrator with firewalls on each side. Users who need access to the Mobile Controller can
connect to it from outside the DMZ zone. This scenario requires that the client-side network firewall have
port 7801 available. The server-side firewall must have ports 22, 80, 443, 7800 and 7870 open.
If you are using application control, you need to allow rbtdebug.exe, rbtmon.exe, rbtsport.exe, and
shmobile.exe.
Figure 1-2. Mobile Controller Deployment

3. Installing on a Rack

If your appliance has a bezel, remove it.

Align the screw holes on the flanges with the screw holes on the rack.

Insert and tighten the screws on each side of the appliance.


4. Connecting the Power

If your appliance has a master power switch, make sure it is in the off position (on the rear panel).

Plug the power cord or cords into the Mobile Controller and an AC outlet.

If your appliance has a master power switch, press the master power switch (ON).

Press the system power switch on the front of the Mobile Controller.

CAUTION: In all European electrical environments, you must ground the Green/Yellow tab on the power cord. If you
do not ground the Green/Yellow tab, it can cause electrical shock.
16
Installing and Deploying the Mobile Controller
Getting Started Guide