Connecting The Interceptor To Your Network - Riverbed SteelHead Manual De Instrucciones

Tabla de contenido

Publicidad

Installing the Interceptor
After you have performed the initial configuration of the Interceptor, you must configure and enable
the in-path IP address. For example, at the system prompt enter the following set of CLI commands:
Interceptor > enable
Interceptor # configure terminal
Interceptor (config) # interface inpath0_0 ip address 10.0.0.10 /24
Interceptor (config) # ip in-path-gateway inpath0_0 10.0.0.1
Interceptor (config) # in-path interface inpath0_0 enable
Interceptor (config) # write memory
Interceptor (config) # service restart

6. Connecting the Interceptor to Your Network

Plug a straight-through cable into the Primary port of the Interceptor and the LAN switch. The
primary port can be any port on your LAN switch that is configured to connect to a host.
Plug a straight-through cable into the LAN port of the Interceptor and the LAN switch. The LAN port
can be any port on your LAN switch that is configured to connect to a host.
Getting Started Guide
Installing SteelHead Product Family Appliances (English)
21

Publicidad

Tabla de contenido
loading

Tabla de contenido