English
※ 24V System Test Printing: The printer will not
function for 24 Volt batteries
system test printing. The 24V
system test result will be
recorded till you hook up to a 12V battery and the
right screen shows up. Please select "YES" and
press enter key to print the result and then
disconnect the clamps. The screen will appear
again after you reconnect the clamps. Please
select "NO" and press the enter key to go back to
the main menu.
15. Press «ENTER» return to step 5 or remove the test
clamps from the battery posts after completion of testing
batteries to end test.
START-STOP TEST
1.
Press the ◄ ► key to select start-stop test. Press
«ENTER» button.
2.
Press the ◄ ► key to select
the battery type:
a.
EFB
b.
AGM FLAT PLATE
Press «ENTER» to confirm choice.
3.
Press the ◄ ► key to select
the battery rating: SAE, EN,
IEC or DIN.
Press «ENTER» to confirm choice.
4.
Press the ◄ ► key to input
the battery capacity of SAE:
• SAE:40~2000
• EN:40~2100
• IEC:30~1500
• DIN:25~1300
Press «ENTER» to begin the test.
- GB.11-V1 -
PRINT 24V SYSTEM
RESULT?
YES
Example :
BATTERY TYPE ◄► ↵
EFB
SELECT RATING ◄► ↵
SAE
SET CAPACITY ◄► ↵
×××× SAE
12
Surface Charge Notice
The battery will hold a surface charge if the engine has
been running or after the battery has been charged. The
tester may prompt you to remove the surface charge.
b.
Follow the instructions indicating when to turn
the headlights on and off or apply a load into
the battery.
In Vehicle
SURFACE CHARGE
TURN HEADLIGHTS
IN VEHICLES? YES
ON FOR 15 SECS
Out of Vehicle
SURFACE CHARGE
TESTING
IN VEHICLES? NO
b.
The tester will resume testing after it detects
that the surface charge is removed.
5.
Test the battery for few
seconds.
6.
Press the ◄ ► key to select
battery fully charged or not if
tester asks. Press «ENTER»
to confirm choice.
7.
When the test is completed, the display shows the
actual volts and the actual SAE or %. {Press the◄ ►
key to select: SOH (STATE OF HEALTH) or SOC
(STATE OF CHARGE)}.
13
- GB.12-V1 -
English
TESTING
IS BATTERY ◄► ↵
CHARGED? YES