Frequently Asked Questions; Technical Data - Marmitek Invisible Control 2 Modo De Empleo

5.

FREQUENTLY ASKED QUESTIONS

x
In a few cases, the Receiver may be disrupted by interference and cannot,
therefore, pick up the signals it receives. If this is the case the red light will
be continuously illuminated than the Receiver must be relocated. This
interference is caused by equipment in the vicinity such as dimmers,
energy-saving light bulbs, IR alarms and so on. Direct sunlight can also
disrupt the Receiver.
x
Invisible Control does not work with remote controls which use High
Frequency signals (such as B&O).
x
Please ensure that the LEDs of the IR extender cable are placed correctly
to the infrared sensor of the A/V device, this has to be done very precisely.
The exact position can be found easily by shining at it with a flashlight.
x
Some IR windows from set-top and satellite boxes are very sensitive and
are easily disrupted. These devices then receive too much infrared light
and will either work badly or not work at all. Relocate the IR LED so that
less infrared light is received via the IR window.
Do you have other questions that have not been resolved by the above
information? Please go to
6.

TECHNICAL DATA

Invisible Control 2™ module
Power:
IR LEDs connections:
Frequency range:
IR reception range:
IR reception angle:
Dimensions:
IR Extension cable
Connection:
IR LEDs:
Length of cable:
Specifications may change without prior notice.
INVISIBLE CONTROL 2™
www.marmitek.com
DC 12V 200mA adapter
2 x 3.5 mm jack plug (mono)
30-60 KHz.
± 8 metres.
60° (+30°/-30° from centre).
90 x 75 x 30mm
3.5mm jack plug
2x IR LED
3 metres (from plug to division 2m, from
division to LED 1m).
5