Descargar Imprimir esta página

Gude GHS 4200 PIEZO Traducción Del Manual De Instrucciones Original página 20

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 57
connected to a circuit that will automatically
switch on and off.
Attention! A damaged cord of this apparatus
must be replaced by the manufacturer or his
customer service or a similarly qualified person,
to prevent hazards.
Flammable materials should be kept at a safe
distance of at least 1 meter from the apparatus.
Do not use or store explosive or flammable
materials (e.g. fuel, paper, paints) in the vicinity
of the product.
Select a place to install the apparatus where
inadvertent contact can be prevented.
Keep the heater clean.
Protect the electrical parts from moisture. To
prevent electrical shock, never submerse these
parts in water or other fluids during cleaning or
when in operation.
Never hold the apparatus under flowing water.
Switch off the apparatus, disconnect it from
mains by unplugging and allow it to cool down
before setting up, retrofitting, cleaning,
performing maintenance, storing or transporting
the apparatus.
Always pull the mains plug when the heater is
not in use.
Do not tug at the cable to unplug the apparatus.
WARNING! To prevent overheating, never cover
the heater with anything.
This appliance may only be used outdoors,
however, it must be always protected against
moisture or rain and MUST NOT BE used at
temperatures below 0°C.
The appliance may only be used for heating
purposes.
Caution! Sealing test with open fire is strictly
prohibited.
Not to be put into operation beneath the Earth's
surface.
Never carry or lift the appliance when in
operation.
Never lift the appliance by any of its part when
attached to a bottle.
Never ignite the appliance near the nozzle on
the back.
The radiant surface must be at least 2 m from
any flammable substances.
Keep a distance of 50 cm between the walls and
rear part or sides of the appliance.
Close immediately the gas bottle valve and put
the appliance outside any source of fire in case
of gas leak (smell).
Make sure all connections are tight.
If gas keeps leaking, an expert must necessarily
be contacted before putting the appliance into
operation the next time.
The appliance installation and servicing must
meet applicable laws and regulations of the
country where it is used.
Never turn the gas bottle upside down, even if it
seems to be empty! It could cause the hose to
get clogged with remains from the gas bottle and
therefore a risk of fire and immediate damage to
the appliance.
Never remove the safety screen and/or other
parts of the burner.
Keep children in a safe distance from the burner.
Never let the appliance unattended!
Instructions for installation and first putting the
appliance into operation
Never use the appliance near flames, sparks and
flammable substances.
MINIMUM DISTANCE OF 2 M TO BE NECESSARILY
KEPT!!!
Fitting the appliance to the gas bottle (pic. 2-5)
Step 1
Make sure all components are standing safely. Make sure
the socket heater, gas hose and gas bottle are safe.
Step 2
To fix the stand (3) on the bottle, use the clamping screw
(4).
Step 3
Screw the pressure controller (11) and the gas hose (10)
on the gas bottle valve.
Step 4
Use the wing nut (8) and the toothed disk (9) to put the
heater to the required position and fix it on the stand (3).
Step 5
Screw the other end of the gas hose (10) to the safety
valve (7).
Step 6
Make sure all the screwing is tight.
Before putting the appliance into operation, check
necessarily the screw caps for any gas leak using a
leak detection spray or lye soap. Retighten them if
necessary.
Changing the gas bottle
Whenever being outdoors alone, keep distance
from the flames or sources of fire and proceed
as follows!
Close the gas bottle valve.
Unscrew the pressure reducing valve (11).
Unscrew the clamping screw (4) and remove the
appliance.
Find out if there is pressure controller sealing in
place.
Put the appliance on a new gas bottle and
continue as specified in "Instructions for
installation and putting the appliance into
operation".
Marking
Product safety:
Product corresponds to
applicable EU standards
Prohibitions:
No fire!
No smoking!
Warning:
Warning/Caution
No operation in enclosed
spaces!
Warning against hot
surface

Publicidad

loading

Este manual también es adecuado para:

17306