Packing List; User'S Manual - Homelite HBP-30 Manual De Utilización

GB
F D E
ASSEMBLY

PACKING LIST

- Blower
- Elbow
- Bellows
- Upper Tube
- Large Clamps (2)
- Small Clamp
- Cable Tie
- Straight Tubes (2)
- Nozzle
- Harness Straps (2)
- 2-Stroke Engine Oil
- Operator's Manual
WARNING
If any parts are missing do not operate this tool
until the missing parts are replaced. Failure to do
so could result in possible serious personal injury.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
NOTE: Read and remove all hang tags and store with
your Operator's Manual.
WARNING
Stop the engine and disconnect the spark plug
wire before installing parts, making adjustments,
cleaning, or when not in use. Failure to do so
could result in possible serious personal injury.
ASSEMBLING THE BLOWER TUBES (Figure 2-5)
Place large clamp (2) on the elbow tube (3) and
■
install the elbow tube onto blower (1). Tighten large
clamp securely.
Place large clamp on the bellows (4) and install the
■
bellows onto the elbow. Tighten clamp securely.
Insert upper tube (15) into throttle control handle (7).
■
Position the throttle control handle in the center of
upper tube and tighten wing nut (16) securely.
I P NL S DK N FIN GR HU CZ RU
English
Note: The position of the throttle control handle may
be adjusted for the best comfort after the blower is
strapped onto the operator's back.
Place small clamp (6) on the bottom end of the
■
bellows (4) and install the upper tube (15) onto the
bellows; tighten clamp securely.
Join two straight tubes (14), thread into the upper
■
tube and tighten securely.
Thread nozzle (10) onto tube assembly and tighten
■
securely.
Tighten all threaded joints securely.
■
Note: Check all threaded joints after initial run to
ensure they are tightened securely.
Hold the throttle cable against the bellows and install
■
the cable tie (18). Cable tie should be tight enough to
retain the throttle cable to the bellows but still allow
for movement.
ASSEMBLING HARNESS STRAPS (Figure 6-7)
Place short looped end of the harness strap (19)
■
through the top bracket (21). Open loop and slide
onto extruded end of the bracket (20).
Lace long end of the harness strap through the slot in
■
the backpack frame (22).
Thread the harness strap end through the center of
■
buckle (23) and then through the top toothed portion
and tighten.
Repeat steps to attach the second harness strap to
■
the blower.
ADJUSTING HARNESS STRAPS
Harness straps should be adjusted to a comfortable
position before starting the blower.
To adjust the harness straps:
Blower should be in operating position before
■
adjusting the harness straps. Slip arm through
harness strap and onto shoulder, then repeat for the
other shoulder.
Tighten or loosen each harness strap as needed, until
■
they are adjusted to a comfortable operating position.
Pull on harness straps to secure in buckle.
■
12
RO PL SLO HR TR EST LT
CAUTION
Make all adjustments to the harness straps
before starting the blower to avoid the possibility
of injury.
LV SK BG