Troubleshooting - ResMed S7 Elite Manual Del Usuario

T
ROUBLESHOOTING
+H VJGTG KU C RTQDNGO VT[ VJG HQNNQYKPI UWIIGUVKQPU +H VJG RTQDNGO ECPPQV DG UQNXGF
EQPVCEV [QWT GSWKROGPV UWRRNKGT QT 4GU/GF &Q PQV CVVGORV VQ QRGP VJG WPKV
Problem
No display.
Insufficient air delivered from
the ResMed S7 Elite.
The ResMed S7 Elite does not
start when you breathe into
the mask.
Possible Cause
Power not connected or switch at
back is not on.
Ramp Time is in use.
Air filter is dirty.
Air tubing is kinked or punctured. Straighten or replace tubing.
Air tubing not connected properly. Check air tubing.
Mask and headgear not positioned
correctly.
Plug(s) missing from access port(s)
on mask.
Pressure required for treatment
may have changed.
Power cord not connected
properly.
Power outlet may be faulty.
The ResMed S7 Elite unit not
switched on.
SmartStart not on.
Leak Alert has been enabled;
SmartStart has automatically been
disabled.
Use of a Mirage Full Face Mask.
Breath is not deep enough to
trigger SmartStart.
There is excessive leak.
Solution
Ensure the power cable is
connected and that the switch at
the back of the unit is in the ON
position.
Wait for air pressure to build up.
Replace air filter.
Adjust position of mask and
headgear.
Replace plug(s).
See your clinician to adjust the
pressure.
Connect power cord firmly at both
ends.
Try another power outlet.
Switch power switch at rear of the
ResMed S7 Elite to ON.
Enable SmartStart.
Disable Leak Alert to enable
SmartStart.
SmartStart does not work with a
full face mask as the anti-asphyxia
valve will not allow sufficiently
high pressure on exhalation.
Take a deep breath in and out
through the mask.
Adjust position of mask and
headgear.
Plugs may be missing from ports
on mask. Replace them.
Air tubing not connected properly.
Connect firmly at both ends.
Air tubing kinked or punctured.
Straighten or replace.
T
ROUBLESHOOTING
29