General Troubleshooting - ResMed AirStart10 APAP Guia Del Usuario

To remove the SD card:
1. Open the SD card cover.
2. Push in the SD card to release it. Remove the SD card from the device.
Place the SD card in the protective folder and send it back to your care provider.
For more information on the SD card refer to the SD card protective folder provided with your
device.
Note: The SD card should not be used for any other purpose.
Traveling
You can take your AirStart 10 device with you wherever you go. Just keep the following in mind:

Use the travel bag provided to prevent damage to the device.

Empty the water tub and pack it separately in the travel bag.

Make sure you have the appropriate power cord for the region you are traveling to. For
information on purchasing, contact your care provider.

If you are using an external battery, you should turn off the humidifier in order to maximize the
life of your battery. Do this by turning the Humidity Level to Off.
Traveling by plane
Your AirStart 10 device may be taken on board as carry-on luggage. Medical devices do not count
toward your carry-on luggage limit.
You can use your AirStart 10 device on a plane as it meets the Federal Aviation Administration (FAA)
requirements. Air travel compliance letters can be downloaded and printed from www.resmed.com.
CAUTION
Do not use the device with water in the water tub on a plane due to the risk of inhalation of
water during turbulence.
Troubleshooting
If you have any problems, have a look at the following troubleshooting topics. If you are not able to
fix the problem, contact your care provider or ResMed. Do not try to open the device.

General troubleshooting

Problem/possible cause
Air is leaking from around my mask
Mask may be fitted incorrectly.
Solution
Make sure your mask is fitted correctly. See your mask user
guide for fitting instructions.
English 9