Screen Settings - Elcometer 319 S Guia Del Usuario

R
4 GETTING STARTED (continued)
To access the language menu when in a foreign language:
1 Switch the gauge OFF.
2 Press and hold the left softkey and switch the gauge ON.
3 Select your language using the

4.3 SCREEN SETTINGS

A number of screen settings can be defined by the user via
Menu/Setup/Setup Backlight including:
Backlight Brightness; This can be set to 'Low', 'Medium' or
Ÿ
'High'.
Backlight Timeout; The display will dim if inactive for the
Ÿ
period defined by the user. To adjust the backlight timeout use
é
the softkeys to highlight 'Backlight Timeout' and press
ê
'Sel'. Use the
0 (off) and 60 seconds - and press 'Ok' to set or 'Esc' to
cancel.
The gauge can also be set to switch off automatically after a user
defined period of inactivity - between 1 and 10 minutes - via
Menu/Setup/Auto Switch Off.
Note: 'Auto Switch Off' is disabled when the gauge is powered by the USB
connection.
4.4 SETTING UP THE READING DISPLAY
The user can select up to five climatic parameters to be displayed
on screen. Measurements are taken for all climatic parameters but
only those selected are displayed. Users can select from:
RH; % Relative Humidity
Ÿ
Ts; Surface Temperature
Ÿ
Ta; Air Temperature
Ÿ
Td; Dewpoint Temperature - calculated from Ta and RH
Ÿ
TΔ; Delta Temperature - the difference between surface
Ÿ
temperature and dewpoint
Tdb; Dry Bulb Temperature - equal to Ta
Ÿ
en-5
é
softkeys to set the required value - between
ê
é
softkeys.
ê
www.elcometer.com