Budda BULLY Manual De Instrucciones página 30

(47) Return
Similar to Return (42) above but for Effects Loop 2.
(48) Mix
Similar to Mix (43) above but for Effects Loop 2.
If Channel mode is selected, this will control the mix of the effect on Channel 2.
If Master mode is selected it will control the mix of the effect on the overall sound, regardless of the
channel selected.
(49) Global – Parallel/Series
This determines the routing of the signal around the effects loops.
In Parallel setting, the normal (dry) signal (from whichever channel is being used) is effectively 'hard
wired' to go directly around the effects loops unaltered. Therefore, any effects that are applied are always
in parallel with the dry signal, which ensures tonal integrity.
In Series mode, the direct signal path is turned off and the whole signal is passed to the effects loop
circuitry. Therefore, the user has complete control over the mix of dry and effects signals for each
channel by using the controls as described above. Due to the design and very high quality of the parts
used, the effects loop circuitry will be sonically transparent.
Effects Loop 3
This is the dedicated effects loop for Channel 3. It will only be available for use when Channel 3 is
selected. It can be switched on and off using the footcontroller.
(50) Level
This control sets the level of Channel 3 signal being sent to external effects and/or signal processors from
the Send jack (51). It is calibrated the same as Level (40) above.
(51) Send
Similar to Send (41) above but for Effects Loop 3.
It will only send signal if Channel 3 and Effects Loop 3 are selected.
(52) Return
Similar to Return (42) above but for Effects Loop 3.