Tabla de contenido
Publicidad
POWER AMPLIFIER SECTION
Four EL34 tubes with 12AX7 phase splitter / driver
120 Watts RMS into 16, 8 or 6 Ohms
(typically @ 5% THD, 1 kHz, 120 VAC line)
100 Watts RMS into 16, 8 or 4 Ohms
+/-3 dB, 50Hz to 20kHz @ 90 Watts RMS into 8 Ohms
Greater than 76dB below rated power
Domestic: 400 Watts, 50/60 Hz, 120 V AC
Export: 400 Watts, 50/60Hz, 220-230/240 V AC
PREAMP SECTION:
Six 12AX7 tubes
Over-Boost off
All EQ controls mid way
Channel Volumes @ maximum
Master Volume @ half way
Boost on and @ maximum
Resonance and Presence control @ mid way
Effects loops off
Nominal levels are with Gain @ mid way
All levels increased by 10dB if using Medium input.
Nominal input level: -12dBu, 200mV RMS
Nominal input level: -46dBu, 4mV RMS
Nominal input level: -58dBu, 1mV RMS
Load impedance: 1k Ohms or greater
Minimum Output: -32dBu, 0.02mV RMS (with –20dBu
signal)
Maximum Output: +1dBu, 1.6V RMS (with 0dBu signal)
Unity gain with Send set at mid position, -10dB at min,
+4dB at max.
Impedance: 100k Ohms
Minimum Input Sensitivity: -12dBu, 0.18mV RMS
Maximum Input Sensitivity: +10dBu, 2.5V RMS
Nominal output level: +4dBu, 1.2V RMS
Load impedance: 1k Ohms or greater
Minimum Input Sensitivity: 0dBu, 0.775V RMS (with
Master on max)
Maximum Input Sensitivity: +6dBu, 1.6V RMS (with
Master on half)
Input impedance: 250k Ohms
Maximum output level: +22dBu, 10V RMS (at full
power)
Load impedance: 10k Ohms or greater
REMOTE FOOTCONTROLLER:
Special ten-button metal footswitch with LED indicators
and detachable cord (supplied). Selects between three
channels, Over-Boost, three effect loops, Reverb, and
Master Boost as well as nine Preset modes.
(Clean channel – 20Hz to 20kHz unweighted)
Greater than 74dB below rated power
Specifically designed bass, mid & treble passive-type EQ
on each preamp channel.
Resonance and Presence damping EQ on each channel.
11.5" (292mm) H x 28.25" (717mm) W x 11.25" (286mm) D
60.6 lbs (27.55 kg)
Publicidad
Tabla de contenido
