Budda BULLY Manual De Instrucciones página 31

BULLY™ GUITAR AMPLIFIER
(53) Mix
Similar to Mix (43) above but for Effects Loop 3.
NOTE: Effects Loop Return Circuitry
(54) Power Amp In / PreAmp Out
This ¼" jack facilitates a simple way to link together two BULLY amps if required. This is a passive,
bidirectional connection that just requires the use of a standard shielded cable with ¼" mono (TS) phone
plugs. Simply connect from one amp to another and the same signal will be heard from both amps. The
signal is taken from and/or injected after all the controls except the Master Volume.
(55) Impedance
This three-position slide switch allows the selection of speaker enclosure impedance. If one enclosure
is used, simply set this to the impedance rating marked on the back of the cabinet. If two enclosures of
equal impedance are used, the switch should be set to half the individual value. For example, two
16 Ohm enclosures would necessitate an 8 Ohm setting, while two 8 Ohm enclosures would require a 4
Ohm setting. Minimum speaker impedance is 4 Ohms.
(56) Speaker Outputs
These paralleled ¼" mono (TS) jacks are provided for the connection of speaker enclosures. The
Impedance switch (55) should be set to match the load of the speaker cabinet(s), as described above.
Always use good quality speaker cables (not shielded instrument cable) for these connections.
(57) Level
This sets the level of the signal at the Slave output (58). If slaving to an effects unit or other device, use
the unit's sensitivity LED lights as a gauge to set the slave level, thereby using this control to avoid
overloading the input of the effects unit or slave amp.