Budda BULLY Manual De Instrucciones página 33

BULLY™ GUITAR AMPLIFIER
(61) HT Fuse
This fuse is for the high voltage supply for the tubes. Sometimes when a tube goes faulty it will result in
this fuse blowing. A fuse is included because without it, collateral damage could occur that could be even
more inconveniencing. The fuse is located within the cap of the fuse holder. This fuse must be replaced
with one of the same type and value to avoid damaging the amplifier and voiding the warranty. If the amp
repeatedly blows the fuse, it should be taken to a qualified service center for repair.
(62) IEC Mains Connector
This is a standard IEC power connector. An AC power cable having the appropriate AC plug and ratings
for the intended operating voltage is included in the carton. The Power Cable should be connected to the
amplifier before connecting to a suitable AC outlet.
U.S. Domestic AC Power Cable
NOTE FOR UK ONLY:
(63) Mains Fuse
This fuse is for the mains supply for the amp. The fuse is located within the cap of the fuse holder. This fuse
must be replaced with one of the same type and value to avoid damaging the amplifier and voiding the
warranty. If the amp repeatedly blows the fuse, it should be taken to a qualified service center for repair.