Conservator VPS10FGMWW Manual Del Propietario E Instrucciones De Instalación página 10

Installation Instructions
REVERSING THE DOOR SWING (CONT.)
WARNING
Follow all steps when reversing the door swing. Failure to follow these instructions, leaving off
parts, or overtightening screws, can lead to the door falling off and result in injury and property damage.
REINSTALLATION
1. Remove the lower hinge pin from the lower hinge
by turning counter clockwise. Move the pin to the
opposite hole and tighten.
Bottom
2. Tilt refrigerator on a 45-degree angle to have access
to the bottom front.
CAUTION
Two People Required
3. Remove both left and right front feet from bottom.
4. Loosen the screws holding the bottom hinge and
remove it.
5. Align the holes in the bottom hinge to the
corresponding holes on the opposite side of the
cabinet. Insert and tighten the screws. Reinstall both
front feet.
10
Lower
Hinge Pin
Bottom
Hinge
6. To install refrigerator door: Line up the left bottom
hole of the refrigerator compartment door over
the bottom hinge pin. Move door forward to make
it straight and align with middle hinge. Install the
middle hinge again, and turn the hinge pin until it
completely enters the door body. Secure it with the
screws provided.
Doorstopper
(left side)
Middle
Hinge Pin
NOTE: Remove plugs from doorframe and install on
other side.
door over the middle hinge middle pin. Move door
compartment. Place the hinge cover over the left
side of the top hinge, align holes with hole on the
refrigerator top and tighten with the screws provided.
Insert the top hinge plug into the holes on the
cabinet top from which you previously removed the 3
hinge screws
Screw
Holes
Middle
Hinge
49-1000110 Rev. 0