Installation Instructions
Explosion and Fire Hazard
Keep flammable materials and vapors, such as
gasoline, away from appliance.
Failure to do so can result in death, explosion or
fire.
REFRIGERATOR LOCATION
IMPORTANT: This refrigerator is designed for free-
standing installation only. It should not be recessed or
built-in an enclosed cabinet. To ensure your refriger-
in a location where there is proper air circulation, and
electrical connections.
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run
often enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not
perform properly.
• Install it on a floor strong enough to support it fully
loaded.
• Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
LEVELING REFRIGERATOR
• Your refrigerator has two leveling legs that
are located in the front bottom corners of your
refrigerator. After properly placing your refrigerator
under its final position, you can level your
refrigerator.
• Leveling legs can be adjusted by turning them
clockwise to raise your refrigerator or by turning
them counterclockwise to lower your refrigerator.
The refrigerator door will close easier when the
leveling legs are extended.
Raise
8
WARNING
Lower
PROPER AIR CIRCULATION
• To ensure your refrigerator works at the maximum
efficiency it was designed for, you should
install it in a location where there is proper air
circulation, plumbing and electrical connections.
Your refrigerator is not designed to operate in
• Do not install your refrigerator in any location not
out of direct sunlight and away from heating sources
such as radiators, heaters, and cooking appliances.
• The following are recommended clearances around
the refrigerator:
Sides . . . .
Top . . . . .
Back . . . .
DOOR ALIGNMENT
Freezer Door
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a hex-head
screwdriver.
3. Adjust the door or put a spacer in between and
then tighten the screws.
4. Replace the top hinge cover.
Hinge
Cover
Top
Hinge
49-1000110 Rev. 0