Recognition Modes; User Registration In 1:N Mode - Fermax FPAC-MAX Manual De Instalación

Cod. 970077b V04_21
7. We will configure the fingerprint reader the new ip address, subnet mask, port and RS-
485 address parameters and at the end we will click
Note: RS-485 address is the parameter that defines the address of the device on the bus.
Range 101-115. This assigned address cannot be repeated on any other bus device
connected to the same controller.

4.1.2 Recognition modes

In case of FPAC-MAX Fingerprint READER, it is necessary to select one of the following
recognition modes:
•
1:N mode (templates in reader's memory): In this mode, fingerprint templates are recorded
in the memory (database) of FPAC-MAX FINGERPRINT READER. Users identify themselves by
comparing their fingerprints with fingerprint templates recorded in the reader's memory.
•
1:1 mode (templates on Mifare cards): In this mode, fingerprint templates are recorded
only on Mifare cards and not on the reader's memory. Users are identified by comparing their
fingerprints with fingerprint templates recorded in Mifare card memory.

4.2 User registration in 1:N mode

In 1:N mode,user registration, including fingerprint scanning and access rights assignment, is
performed in AC-MAX software. We recommend that you use user management wizards. To
add a new user, select the
Online User wizard,
then the Add
right-clicking in the navigation tree above
Identifiers window
1. In the
field instead of the default,
2. Select the finger to scan, and then select the Read button
3. Select the FPAC-MAX HUELLA READER to scan and then select the Scan
4. Follow according to the displayed messages.
the Add an Online User Wizard and
5. Return to
last step.
6. When the wizard is closed, configure the FPAC-MAX FOOTPRINT READERS by selecting the
Synchronization
icon.
Synchronize
Wizard
command from the top menu of the AC-MAX software, and
and follow the instructions below or in LT directly
Users:
when a new identifier is added, select Fingerprint
Proximity Card 24bit
command in the upper-right corner of the AC-MAX and then the
In the opened window, select the readers and click the Start
Send to device.
.
on the reader.
upload the configuration to the driver in the
Add
User
in
the Type
button.
button.
10 | 16