Console And Gear Shift Installation; Using The Computer; Set Up Instructions - Elite Super Crono Hydromag Digital Instrucciones

CONSOLE AND GEAR SHIFT
INSTALLATION:
• Install the LCD console to the shifting lever (see
the following illustration).
• Connect the wire from the back of the LCD
console to the shifting lever as shown in the
following illustration.
• In case it isn't firmly connected, insert the plug
of the speed sensor (the cable that comes from
the flywheel housing) in the shifting lever, as
shown in the following illustration.
• Make sure the shifter is securely mounted and
that the cable does not interfere with you or the
bicycle while pedal-ling (pedals, chain, etc).
• It is now possible to start the training session.
It is possible to change the resistance level using
the remote regulation shifter installed on the han-
dlebar and view all the data of your training ses-
sion on the LCD display.
1 Supercrono HydroMag Dgt.indd 9
Screen to select the units of measurement.

USING THE COMPUTER

Set up instructions

The first operation with Super Crono Hydromag Digital
is to set your personal parameters.
1
This is possible from the SET UP screen that you may
have access by keeping pressed the right (MODE)
key for at least 3 seconds. SET UP will appear at the
bottom of the screen. By stop pressing the key, the
SET UP screen will appear on the
LCD display.
Attention: the trainer must not be
running to be able to enter the SET
UP screen.
The next step is to select the units
of measurement, which can be me-
tric or Anglo-Saxon.
By pressing the left button (SET),
METER, KM/H, KILO and FOOT, M/H
2
e LB will alternate on the screen. Press the MODE
key to select the desired units and to pass to the next
screen where you can input your personal weight.
In this screen, a three digit number will appear at the
top right corner of the screen which indicates your
weight including your bicycle, in the unit of measu-
rement previously selected. Using the trainer for the
first time, the number that ap-
pears is the figure preinserted at
the factory; from the second time
onwards, it's the figure introdu-
ced the previous run. To amend
the number, press the SET key
to modify the first flashing digit
and the MODE key to confirm the
value selected and pass to the se-
cond digit which will start to flash.
3
Repeat the same operation for all
three digits. Press MODE to con-
firm the weight value and to pass to the next screen.
In this screen the model of resistance unit is selec-
ted. Select value "2" for Super Crono Hydromag Di-
gital. This value should already be preinserted at the
factory; if this is not the case, press the SET key until
the number becomes "2". Press the MODE key to exit
the SET UP screen.
SET
05/11/09 12:21
GB
9